Kwik – Clean Flux & Patina Remover
$31.00
450 ml (16 fl oz)
6 in stock
Description
16 oz. (450 ml) Spray Bottle
Non-toxic, non-caustic and non-corrosive
ELIMINATES ‘WHITE MOLD’ Caused by Flux & Patina being left behind.
Just spray on Kwik-Clean after soldering to clean off the flux. Or spray on Kwik-Clean after applying patina to neutralize and clean up the left-over patina. No water is required for cleaning.
No need to mix or dilute. After you have completed soldering one or both sides of your project, spray on Kwik-Clean. Typically, with a paper towel clean project thoroughly.
You may use the same paper towel or a clean one to apply the patina. Mixing the Kwik-Clean with the Patina gives added cleaning of the flux and a finer tone on the patina.
After Patina is applied, clean again with Kwik-Clean.
Polish as you normally would.
On pieces where White Mold is already present:
For problem climates where White Mold is rampant. Steel wool after the first Kwik-Clean and before the Patina assures a finer clean of flux from under the foil. Then apply your patina & clean again with Kwik-Clean.
Additional information
| Weight | 555 g |
|---|
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.