CJ’s Flux / Patina Remover

Description

Remove oily flux after soldering and you’ll prevent discolouring and oxidation that may occur with time. Just squeeze on flux remover, wipe with a damp sponge, rinse, and dry thoroughly. Flux remover is absolutely safe to use: non-toxic, non-abrasive, non-flammable and water soluble. You’ll find your patinas turn out more uniform when you use CJ’s.

Directions:
Shake before using. Apply CJ’s directly to finished piece immediately after soldering. Scrub entire piece (glass, lead, solder joints) with soft brush and warm water, then rinse clean. If using a patina, apply now and rinse again.

MSDS